Trace metals in interstitial waters from sandstones: acidic inputs to shallow groundwaters

There is some evidence from southern Britain that shallow groundwaters in non-carbonate lithologies may be affected by acidic deposition. To investigate this, interstitial water profiles down to 12 m have been obtained from unsaturated sands or semi-consolidated sandstones from the Folkestone Beds (Lower Greensand) of Surrey and the Sherwood Sandstone of the West Midlands. The pH of the interstitial waters generally increased with depth and reflected an increase in the base saturation of the exchange complex. Beneath the highly acidic surface soil horizons (pH 3.0-3.5), interstitial waters with a pH of 4.0-4.5 were found down to depths of several metres. The pH progressively increased to around pH 5.5 because of base cation desorption and the weathering of silicate minerals. High concentrations of aluminium (10-20 mg litre(-1)) and other metals (Fe, Mn, Cu, Ni, Co, Zn, Be) were found in the interstitial water in the upper unsaturated zone. Most metal concentrations were strongly pH-dependent but also reflected the geochemical characteristics of the parent sands or sandstones. H+ and trace element concentrations were slightly higher beneath areas of afforestation than beneath heathland. The downward fluxes of solutes have been estimated using rainfall-derived chloride as a non-reactive solute. The profiles retain a record of 10-20 years input allowing the past inputs from SO4 and other species to be estimated using solute/chloride ratios. Cation exchange sites are probably depleted over a period of decades and there can be a significant decrease in the unsaturated zone pH as a result of increased or sustained acidic deposition. The shallow groundwater environment (0-15 m) in non-carbonate terrains is therefore a sensitive environment where high metal concentrations may be generated and may ultimately lead to water quality problems in shallow water supplies.     

邢台市秋季PM2.5及水溶性离子污染特征

为研究邢台市秋季PM_2.5污染特征,于2017年10月15日~11月14日在邢台市区对PM_2.5样品进行了采集,并对其中水溶性离子（包括Cl^-、NO₃^-、SO₄^2-、NH₄⁺、Ca²⁺、Na⁺、Mg²⁺、K⁺）进行了分析.结果显示,观测期间邢台市ρ（PM_2.5）平均值为（130.0±74.9）μg/m³,其中水溶性离子质量浓度为（69.8±11.4）μg/m³,占ρ（PM_2.5）的53.3%,NO₃^-、SO₄^2-和NH₄⁺为主要离子,占水溶性离子比例达到了89.7%. 当污染加重,水溶性离子质量浓度随ρ（PM_2.5）增大而升高,且NO₃^-、NH₄⁺及SO₄^2-占比亦逐渐升高,但其他离子占比随之下降,Ca²⁺尤为明显,表明ρ（PM_2.5）升高时主要受二次无机转化影响;观测期间SOR（硫转化率）与NOR（氮转化率）的平均值分别为0.36和0.25,表明秋季SO₂与NO₂转化速率较强,二次无机污染严重,另外SOR及NOR与温度及相对湿度呈正相关,且SOR对二者更为敏感;邢台市秋季PM_2.5呈弱碱性,NH₄⁺主要以（NH₄）₂SO₄和NH₄NO₃的形式存在;ρ（NO₃^-）/ρ（SO₄^2-）平均值为2.13,表明移动源对秋季大气颗粒物的来源贡献较大;PMF分析结果表明,二次转化源、燃烧源及扬尘源为邢台市秋季PM_2.5中水溶性离子的主要来源.     

‘Emulsion locks’ for the containment of hydrocarbons during surfactant flushing

Reversible double water in oil in water (W/O/W) emulsions were developed to contain subsurface hydrocarbon spills during their remediation using surfactant flushing. Double emulsions were prepared by emulsifying CaCl₂ solutions in canola oil, and subsequently by emulsifying the W/O emulsions in aqueous sodium alginate solutions. The formation of double emulsions was confirmed with confocal and optical microscopy. The double emulsions reversed and gelled when mixed with the surfactants sodium dodecyl sulfate (SDS) and cocamidopropyl betaine (CPB). Gels can act as ‘emulsion locks’ to prevent spreading of the hydrocarbon plume from the areas treated with surfactant flushing, as shown in sand column tests. Shear rheology was used to quantify the viscoelastic moduli increase (gelation) upon mixing the double emulsion with SDS and CPB. SDS was more effective than CPB in gelling the double emulsions. CPB and SDS could adsorb at the interface between water and model hydrocarbons (toluene and motor oil), lowering the interfacial tension and rigidifying the interface (as shown with a Langmuir trough). Bottle tests and optical microscopy showed that SDS and CPB produced W/O and O/W emulsions, with either toluene or motor oil and water. The emulsification of motor oil and toluene in water with SDS and CPB facilitated their flow through sand columns and their recovery. Toluene recovery from sand columns was quantitated using Gas-Chromatography Mass-Spectroscopy (GC-MS). The data show that SDS and CPB can be used both for surfactant flushing and to trigger the gelation of ‘emulsion locks’. Ethanol also gelled the emulsions at 100 mL/L.     

An investigation of changes in water quality throughout the drinking water production/distribution chain using toxicological and fluorescence analyses

Changes in water quality from source water to finished water and tap water at two conventional drinking water treatment plants(DWTPs) were monitored.Beside the routine water quality testing,Caenorhabditis elegans-based toxicity assays and the fluorescence excitation–emission matrices technique were also applied.Both DWTPs supplied drinking water that met government standards.Under current test conditions,both the investigated finished water and tap water samples exhibited stronger lethal,genotoxic and reprotoxic potential than the relative source water sample,and the tap water sample was more lethal but tended to be less genotoxic than the corresponding finished water sample.Meanwhile,the nearly complete removal of tryptophan-like substances and newly generated tyrosine-like substances were observed after the treatment of drinking water,and humic-like substances were identified in the tap water.Based on these findings,toxic pollutants,including genotoxic/reproductive toxicants,are produced in the drinking water treatment and/or distribution processes.Moreover,further studies are needed to clarify the potentially important roles of tyrosine-like and humic-like substances in mediating drinking water toxicity and to identify the potential sources of these contaminants.Additionally,tryptophan-like fluorescence may be adopted as a useful parameter to monitor the treatment performance of DWTPs.Our observations provided insights into the importance of utilizing biotoxicity assays and fluorescence spectroscopy as tools to complement the routine evaluation of drinking water.     

Removal and desorption of chromium in synthetic effluent by a mixed culture in a bioreactor with a magnetic field

Two chromium removal experiments were performed in bioreactors with and without a magnetic field under the same conditions.The release of the chromium present in the biomass was tested in two experiments one with the initial pH of the medium and one with pH 4.0.The objective was to remove Cr(Ⅵ) and total Cr from the effluent,this was carried out by placing biological treatments of synthetic effluent contaminated with 100 mg/L of Cr(Ⅵ) in a bioreactor with neodymium magnets that applied a magnetic field(intensity85.4 mT) to the mixed culture.The removal of Cr(Ⅵ) was approximately 100.0% for the bioreactor with a magnetic field and 93,3% for the bioreactor without a magnetic field for9 hr of recirculation of the synthetic effluent by the bioreactor.The removal of total Cr was61.6% and 48.4%,with and without a magnetic field,respectively;for 24 hr.The desorption of Cr(VI) in the synthetic effluent was 0.05 mg/L,which is below the limit established by Brazilian legislation(0.1 mg/L) for the discharge of effluent containing Cr(Ⅵ) into bodies of water.The results obtained for the removal of chromium in synthetic effluent suggested that there was no significant influence on the viable cell count of the mixed culture.The desorption of Cr(Ⅵ) in synthetic effluent after bioadsorption of chromium by the mixed culture in the process of removal of chromium in bioreactors with and without a magnetic field was not significant in either of the experiments with different initial pHs.     

银川市冬季PM2.5重污染特征、来源与成因分析

近年来银川市冬季重污染过程频发,为明确银川市冬季PM_2.5重污染的特征,分析其主要来源及成因,于2016年12月-2017年1月在银川市选取3个采样点开展PM_2.5的样品采集与化学组分分析,利用CMB（化学质量平衡）模型对银川市冬季PM_2.5进行来源解析,对比分析了重污染日与非重污染日污染特征的差异.结果表明:①银川市冬季重污染日ρ（PM_2.5）[（181±33.6）μg/m3]是非重污染日的2.1倍;重污染日和非重污染日的ρ（NO₃-）/ρ（SO₄2-）均小于1,表明燃煤仍是银川市冬季PM_2.5的重要来源.银川市冬季PM_2.5中ρ（SOC）为（14.4±7.34）μg/m3,约占ρ（OC）的65.2%.②与非重污染日相比,重污染日人为源无机元素As、Pb、Cd和Zn质量浓度在ρ（PM_2.5）中的占比分别升高33.2%、18.4%、9.8%和2.9%,表明银川市冬季重污染主要受人为源贡献影响.③源解析结果表明,燃煤源、机动车尾气源、二次离子源和扬尘源是银川市PM_2.5的主要污染源,与非重污染日相比,重污染日机动车尾气源的贡献率明显降低.研究显示,银川市冬季重污染受人为源污染物排放的影响较大,燃煤源是银川市冬季PM_2.5的重要来源.